Chassis

Please donate to the cause if you can, all funds will go towards the ongoing GX200 Eggmotor project. Thank you.

These are the plans and rough wire model of the desired Eggmonster prototype.

 

Monster plans

Monster plans

The following is a brief insight into the frame fabrication. The dimensions of the tube used are 20mm x 20mm x 1.5mm thick and thankfully Sam managed to get over 4 metres of the stuff.

This is more than enough for the main frame/engine mount section.

Frame cutting

Frame cutting

I even temporarily sat the engine on to see what it’ll be like during construction.

 

Motor on frame

Motor on frame

Motor on frame

Motor on frame

Motor on frame

Motor on frame

Motor on frame

Motor on frame

 

The 16mm round tubing has now been rolled into two 48 inch diameter circles and I have cut and tacked it to the main frame. Sam took it to his work where one of his colleagues did a proper job of the welding.

Frame and cage tacked up

Frame and cage tacked up

Frame and cage tacked up

Frame and cage tacked up

Frame and cage tacked up

Frame and cage tacked up

Advertisements
%d bloggers like this: